Table of Contents
Advertisement
Introduction
1.1
Purpose of this documentation
These instructions contain all information required to commission and use the device. Read
the instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.2
History
This history establishes the correlation between the current documentation and the valid
firmware of the device.
The documentation for this revision is applicable for the following firmware:
Edition
09/2014
The most important changes in the documentation compared with the previous edition are
shown in the following table.
Edition
09/2014
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
Firmware identifier nameplate
As of FW 5.00.00
Note
1. Chapter "Parameter overview (Page 147)"
New parameters and values:
–
1.YFCT - Actuator > Initialization of actuators with inverted direction of action
is now possible.
–
50.PRST - Preset > Resetting of individual parameter groups is now possi-
ble.
–
51.PNEUM > Fail in place function can now be activated with appropriate
pneumatic system.
2. Chapter "Parameter overview (Page 147)"
New functions for the advanced diagnostics parameters:
–
A5.RPMD and A6.RPRT > Partial stroke test is now possible in ramp mode.
–
A7.FLBH > Response following failed PST can now be defined.
3. Chapter "Diagnostics (Page 205)"
Functions for the diagnostics values:
–
7.HOURR - Resettable operating hours counter added
–
11 LEAK > Offline leakage test added.
–
21 P0 and 22 P100 > Modification of upper and lower end stops now possi-
ble without initialization.
–
25 PAUTP > Adjustable no-pulse period added.
1
11
Advertisement
Table of Contents
