Table of Contents
Advertisement
Technical data
14.1
General technical data
SIPART PS2 (all versions)
General data
Range of stroke (linear actuator)
Angle of rotation (part-turn actuator)
Installation
On the linear actuator
•
On the part-turn actuator
•
Control unit
Five-point controller
•
Dead zone
•
dEbA = auto
dEbA = 0.1 ... 10 %
Analog-to-digital converter
Scanning time
•
Resolution
•
Transmission error
•
Temperature influence
•
Cycle time
20 mA/HART device
•
PA device
•
FF device
•
Binary input BE1 (clamp 9/10; galvanically connected with
basic device)
Degree of protection
)
1
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
3 ... 130 mm (0.12 ... 5.12") (angle of rotation of the
feedback shaft 16 ... 90°)
30 ... 100°
Using the mounting kit 6DR4004-8V and, if required, an
additional lever arm 6DR4004-8L on the actuators as per
IEC 534-6 (NAMUR) with a fin, columns, or a plane
surface
Using the mounting kit 6DR4004-8D on the actuators with
fastening plane as per VDI/VDE 3845 and DIN 3337: The
required mount must be provided on the actuator-side;
shaft with groove, and M6 female thread.
Adaptive
Adaptive or can be preset
Adaptive or can be preset
10 ms
≤ 0,05 %
≤ 0,2 %
≤ 0.1 %/10 K (≤ 0.1 %/18 °F)
20 ms
60 ms
60 ms (min. loop time)
Only usable for a dry contact; max. contact load <5 mA at
3 V
IP66 according to EN 60529 / NEMA 4X
14
243
Advertisement
Table of Contents
