Board Installation - Mitsubishi Electric SW0DNC-MNETH-B User Manual

6 PROCEDURE AND SETTINGS UP TO THE POINT OF OPERATION

6.3.3 Board installation

Power OFF the personal computer.
Install the board to a slot on the personal computer.
Fix the board to a slot on the personal computer using the board-
fixing screws.
Wiring the external power supply cable
For the board with external power supply function, wire the
external power supply cable.
Power ON the personal computer.
WARNING
CAUTION
6 - 8
The following flowchart shows the board installation procedure.
Start
↓
Power OFF
↓
Install the board
↓
Fix the board
↓
↓
Power ON
↓
End
For the installation method of the board to a slot, refer to the instruction manual
provided with the personal computer.
• Be sure to shut off all phases of the external power supply used by the system
before performing work such as installing the board and wiring.
If all power is not turned off, there is a risk of electric shock or damage to the
product.
• When turning on the power and operating the module after having installed the
board and doing the wiring, always attach the cover for the device module in
which the board is installed.
There is a risk of electric shock if the module cover is not attached.
• Fix the board by tighten the board-fixing screws within the specified torque range.
Under tightening may cause malfunction, short circuit, or malfunction. Over
tightening may damage the screw and/or module, resulting in drop, short circuit,
or malfunction. For the tightening torque of the board fixing screws, refer to the
manual supplied with the personal computer.
• Always make sure to touch the grounded metal to discharge the electricity
charged in the body, etc., before touching the board.
Failure to do so may cause a failure or malfunctions of the board.
• Install the board to a personal computer which is compliant with PCI standard or
PCI Express standard (Refer to "Section 2.5 Operating Environment").
R
Failure to do so may cause a failure or malfunction.
• Securely mount the board to the PCI slot of the mounting device.
If the board is not mounted correctly, this may lead to malfunctioning, failure or
cause the board to fall.
Refer to Section 6.4.4
MELSEC
6 - 8