Appendix 3 Procedures For Replacing Boards - Mitsubishi Electric SW0DNC-MNETH-B User Manual

APPENDIX

Appendix 3 Procedures for Replacing Boards

Record the settings before the replacement
Record the channel numbers and parameter settings that were used
before the replacement.
Power OFF the personal computer.
Remove the target board from the personal computer.
Install the target board to a slot of the personal computer.
Fix the board to a slot on the personal computer using the board fixing screws.
For the board with external power supply function, wire the external
power supply cables.
Power ON the personal computer.
Set the channel No. recorded before the replacement.
Test the hardware of the installed board.
Wire the network cables for the installed board.
App - 8
This section explains the procedure to replace a MELSECNET/H board.
(1) Replacement procedure
Start
↓
↓
Power OFF
↓
Uninstall the board
↓
Install the board
↓
Fix the board
↓
Wire the external power supply cables
↓
Power ON
↓
Set the Channel No.
↓
Check the board
↓
Wire the cables
↓
• • • Chapter 7 PARAMETER SETTINGS
Section 9.2.2 Board list screen operation
• • • Section 6.4.4 External power supply
cable wiring
• • • Section 6.3.4 Channel No. Settings
• • • Section 6.5 Test
• • • Section 6.4 Wiring
MELSEC
App - 8