Mitsubishi Electric SW0DNC-MNETH-B User Manual page 170

14 TROUBLESHOOTING
No.
11 CPU modules other than QCPU cannot be accessed.
The utility screen is not displayed properly.
12
The operations of utility cannot be performed.
When transmitting the data using SEND function of
mdSend function, the transmission is completed
13
normally, however, the data is not received at the
destination.
14 The driver does not start up.
14 - 4
Error detail Cause determination method/Corrective action
CPU modules other than QCPU (Q mode) cannot be
accessed to the 64-bit version of user application. Use
32-bit version of user application.
1) Check if the display settings on the [Device
Manager] or other relevant functions are correct,
and install an appropriate display driver.
Or update the Windows
2) Close the other applications.
3) Change the Hardware accelerator setting of the
display setting.
Refer to section 12.3.4.
1) Install the board.
2) Check if the board is recognized normally on the
"Device Manager" screen. (Refer to Section 14.3.3)
3) When the board is recognized normally on the
Device Manager screen, check if an error has
been occurred on the Event Viewer screen. (Refer
to Section 14.3.2)
MELSEC
operating system.
R
14 - 4