Mitsubishi Electric SW0DNC-MNETH-B User Manual page 178

14 TROUBLESHOOTING
Event ID
0 to FFFF
279 (117
280 (118
281 (119
286 (11E
287 (11F
288 (120
295 (127
296 (128
297 (129
304 (130
305 (131
33027 (8103
33029 (8105
1 : If an event error occurs in event viewer, make the following setup setting on the PC.
(Limited to the PC includes those setup setting items.)
Example)
BIOS Setup Utility
Plug & Play O/S
Reset Configuration Data : [No]
Then, restart the PC.
14 - 12
H
) An error occurred when writing to registry database.
H
A request that cannot be processed was received from other
)
H
station.
Retry transmission was executed during transmission
)
H
process.
) Failed to allocate the Memory Area.
H
) Link Parameter is nothing or has abnormal data.
H
The Driver WDT error occurred on the MELSECNET/H board
)
H
driver side.
) The Board WDT error had occurred.
H
) The CLOCK STOP error had occurred.
H
) The Target Abort error had occurred on the PCI bus.
H
) The Data Parity error had occurred on the PCI bus.
H
Entering sleep mode or hibernation mode, or fast startup is
detected.
) The board is not operated normally because the sleep mode,
H
hibernation mode, and fast startup is not supported by the
board.
The driver is not yet started, or an error occurred while
)
H
opening the driver.
An error occurred while resetting the MELSECNET/H board.
One of the following two conditions is suspected as the cause.
1) The common memory area used by the MELSECNET/H
)
H
board may be in contention with other device.
2) No response was received from the MELSECNET/H
board.
: [YES] [No]
[YES]
Error content
MELSEC
Corrective action
• After installing SW0DNC-MNETH-B, restart the
computer and confirm that this error does not
occur.
• Increase the system memory and disk capacity.
• When the error has occurred at updating
R
Windows 8.1 or upgrading the operating
system with the software package installed,
reinstall the software package.
——
——
Increase the memory.
Set the parameter with MELSECNET/H utility,
and reset the board.
Remove another option board.
Take corrective actions for the Driver WDT error.
(Refer to Section 14.7.2.)
Replace the MELSECNET/H board.
Change the power option not to enter the sleep
mode, hibernation mode, or disable the fast
startup function and restart the personal
computer.
Correct the cause of the driver error, then restart
the PC.
1) Check for overlapping setting with other
optional board.
2) Perform memory and I/O diagnosis using the
MNETH utility. If the error persists, replace the
MELSECNET/H board.
14 - 12