Silca Unocode PRO Operating Manual page 46

UNOCODE PRO
Step 3
Enter the depth symbols (numbers or letters) and associate
them to the required cutting depth. Press ENTER to confirm the
value and go from one field to another. All measurements are
expressed in hundredths of a millimetre or inches, according to
the settings in the machine Options (Ch.6.11, page 61)
Note: press F2 to go back to the previous screen.
When editing is complete, press F1 to continue.
Step 4
Enter the cutting space values, from the key stop to the centre of the first cut, then from the centre of the first cut to the
centre of the second cut, and so on. The cut bases can vary from 0 to 200, which is the width of the base of the cut. All
measurements are expressed in hundredths of a millimetre or inches, according to the settings in the machine Options
(Ch.6.11, page 61)
Note: press F2 to go back to the previous screen.
HEAD stop
When editing is complete, press F1 to continue. The display will show:
• Press ENTER to confirm editing.
• Press STOP if you wish to return to the main menu without saving
the data.
42
F1
F2
Copyright Silca 2017
Operating manual - English
number of
depths entered
symbols associated
with depths
TIP stop
depths