Silca Unocode PRO Operating Manual page 47

Operating manual - English
• Editing a card created by Code Maker
This function is used to edit a card previously created by Code Maker. Use the arrow keys to select the card to be edited.
- Press F2 for the editing controls.
- Follow the procedure described above.
ATTENTION: for error messages caused by wrong use of Codemaker, see Ch.6.13.4 "CODEMAKER messages", page 70.
• Deleting a card created by Code Maker
This function is used to eliminate a card previously created by
Code Maker.
• Use the arrow keys to select the card to be deleted.
• Press F3 for the deletion control. The display appears as
follows:
• Press ENTER to confirm deletion.
• Press STOP to stop the operation.
ATTENTION: when a card is deleted the number of that card
cannot be reused.
• Copying a card created by Code Maker
This function is used to speed up the creation of a new card.
• Select the card to be copied and press F4; the display will
show a message asking whether to proceed.
Press ENTER to proceed. A screen appears showing the card to
complete with a description and adjustment, if necessary, of any
key and/or cutting parameters (see paragraph "Creating a card
with Code Maker").
ATTENTION: for error messages caused by wrong use of Codemaker, see Ch.6.13.4 "CODEMAKER messages", page 70.
F3
F4
Copyright Silca 2017
UNOCODE PRO
43