Silca Unocode PRO Operating Manual page 33

Operating manual - English
Modify cutting method
F1
• By pressing F1 it is possible to view the cutting method set by Silca for the card and to modify it when possible
(Ch.6.5.1, page 34).
Note: the editing can be saved as User Parameters.
Use of Electric Contact
F2
• Press F2 to enable or disable the electrical contact function to read the key blank measurements.
The symbol (*) in the clamp field means that the key will be cut reading the key blank
measurements by electrical contact.
A red "X" on the electrical contact icon means that it has been disabled.
Note: some cutting cards do not include electrical contact. In such cases the software does not allow
editing.
Note: the editing can be saved as User Parameters.
F3
• Press F3 to vary the setting for the value of the key blank measurements.
Note: when electrical contact is used it is advisable to set key blank measurements that are the same
as those of the key to be cut.
Copyright Silca 2017
UNOCODE PRO
29