Limited Access To Data (Protected Systems) - Silca Unocode PRO Operating Manual

UNOCODE PRO
• Changing the cutter
For certain cutting methods the standard cutter U01W must be replaced with a specific cutter.
FO21P key:
EXAMPLE WITH
Note: replace the cutter according to the instructions in Ch. 8.3, page 75.
• Use of Adaptors
Some of the data cards provided by Silca may show a new parameter (Adapt.:B...) which indicates the type of accessory
that is needed to cut the key in question (fig. 21, page 26).
See the leaflet included with thee UNOCODE PRO machine.
6.5.2

LIMITED ACCESS TO DATA (PROTECTED SYSTEMS)

Silca has predisposed limited access to some of the data in the Database, in compliance with agreements with some
makers. Limitations apply to:
- DATA CARD: If the key-cutting card is protected, access is denied.
Gain access to protected data in the following way:
- request the maker's authorization.
- communicate to Silca:
- The key-cutting machine SERIAL NUMBER
- The ACTIVATION CODE
- Key-cutting Machine ID
Silca will issue a Password to enter in order to enable key-cutting of
the protected system.
Example: Silca provides a protected data card No 2211.
When card 2211 is selected from menu F1 the following appears on
the screen:
When authorization has been received from the maker, apply to Silca
for a password, providing the following information:
- Key-cutting machine serial No 1170145634567
Read the serial number of the ID plate located on the back of the key-
cutting machine or on the initial screen on the display.
- Machine ID 12345
Visible in the password box.
- ACTIVATION Code WUCSC02211
shown ONLY when access to protected data is attempted.
36
N E
ORMAL ASY
Concerns traditional automotive and door lock keys, the edges
of the cuts are removed (when possible) by a defi -ned value of
around 30 hundredths of a millimeter. Likewi-se even for the
keys tip.
Copyright Silca 2017
Operating manual - English