Pw-Class Encapsulation Mpls - Cisco XR 12000 Series Command Reference Manual

Virtual Private Network Commands

pw-class encapsulation mpls

To configure MPLS pseudowire encapsulation, use the pw-class encapsulation mpls command in L2VPN
pseudowire class configuration mode. To undo the configuration, use the no form of this command.
pw-class class-name encapsulation mpls {control word| ipv4| load-balancing| preferred-path| protocol
ldp| redundancy one-way| sequencing| tag-rewrite| transport-mode| vccv verification-type none}
no pw-class class-name encapsulation mpls {control word| ipv4| load-balancing| preferred-path| protocol
ldp| redundancy one-way| sequencing| tag-rewrite| transport-mode| vccv verification-type none}
Syntax Description
class-name
control word
ipv4
load-balancing
preferred-path
protocol ldp
redundancy one-way
sequencing
tag-rewrite
transport-mode
vccv none
Command Default
None
Command Modes
L2VPN pseudowire class configuration
OL-28460-01
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
pw-class encapsulation mpls
Encapsulation class name.
Disables control word for MPLS
encapsulation. Disabled by default.
Sets the local source IPv4 address.
Sets flow label-based load
balancing.
Configures the preferred path
tunnel settings.
Configures LDP as the signaling
protocol for this pseudowire class.
Configures one-way PW
redundancy behavior in the
Redundancy Group.
Configures sequencing on receive
or transmit.
Configures VLAN tag rewrite.
Configures transport mode to be
either Ethernet or VLAN.
Enables or disables the VCCV
verification type.
69