Timeout Setup (L2Tp) - Cisco XR 12000 Series Command Reference Manual

timeout setup (L2TP)

timeout setup (L2TP)
To configure timeout definitions for L2TP session setup, use the timeout setup command in L2TP class
configuration mode. To return to the default behavior, use the no form of this command.
timeout setup seconds
no timeout setup seconds
Syntax Description
seconds
Command Default
seconds: 300
Command Modes
L2TP class configuration
Command History
Release
Release 3.7.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples The following example shows how to configure a timeout value for L2TP session setup of 400 seconds:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2tp-class cisco
RP/0/0/CPU0:router(config-l2tp-class)# timeout setup 400
Related Commands
Command
authentication (L2TP), on page 4
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
146
Time, in seconds, to setup a control channel. Range is 60 to 6000 seconds. Default
is 300 seconds.
Modification
This command was introduced.
Operations
read, write
Description
Enables L2TP authentication for a specified L2TP class name.
Virtual Private Network Commands
OL-28460-01