Setting The Device Name - Conext XW+ 6848 NA Owner's Manual

Setting the Device Name

975-0240-01-01
The Dev Name setting allows you to customize the name of the Conext XW+ as it
is displayed on other screens and menus.
The characters available are:
• A to Z
• a to z
• 0 to 9
• space
Note: Increasing the number of characters in a device name may cause other
text on the same line to run off the edge of the screen. Device names should be
limited to 10 characters or less.
To customize the Conext XW+ name:
1. On the device setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced Settings on the device
setup menu, display Advanced Settings by pressing Enter + Up arrow +
Down arrow at the same time.
2. Select the Multi-Unit Config menu.
3. Select Dev Name.
4. Press Enter.
The last letter of the Conext XW+ name is highlighted.
5. Begin customizing the device name.
• To change the character, press the up or down arrow button. Holding
down the button causes the characters to scroll more quickly.
• To delete the character, press Exit.
• To add characters, press Enter.
6. When the correct character is shown, press Enter to select it.
7. After pressing Enter to select the last character of your customized device
name, press Enter again to return to the menu.
Note: It is also possible to change the device name using the Conext System
Control Panel and the Conext Configuration Tool. Please refer to the respective
Owner's Guides of these products for further information.
Multi-Unit Config Menu
3–41