Ve Automatic; Adjust Unities; Brightness Of Display - Atmos S 351 Operating Instructions Manual

5.0 Operation
Fig. 37.
30
adjust unity

5.3.4 VE Automatic

You can chose between fully automatic or semi automatic
vacuum build up in the VE Automatic sub-menu (fi g. 37).

Set the type of vacuum build up required using the arrow
buttons.

Accept the settings by pressing the Max button and close
the sub-menu.
If the extraction cup button is pressed, the sub-menu is closed
without saving the changes.
5.3.5

Adjust unities

The vacuum unity displayed can be changed for the ATMOS
S 351 Natal. To do this, press and hold the extraction cup
button while switching on until Service 1 is displayed on the
graphics display.

Then select Adjust unity using the arrow buttons and con-
fi rm with the Max button.

The selection menu for the unities is displayed.
You can chose between mbar, mmHg and kPa.

Select the unity required using the arrow buttons and
confi rm with the Max button.
5.3.6

Brightness of display

The brightness of the graphics display of the ATMOS S 351
can be adjusted to suit the environment. To do this, press and
hold the extraction cup button while switching on until Service
1 is displayed on the graphics display.

Then select LCD Brightness using the arrow buttons and
confi rm with the Max button.

The selection menu for the display brightness is dis-played.
You can set the brightness of the LCD display using the
arrow buttons. When you have adjusted the display confi rm
the setting with the Max button.