Where To Go Next; Additional References - Cisco ASR 9000 Series Configuration Manual

Implementing OSPF
!
neighbor 2.2.2.2
remote-as 10
update-source Loopback0
address-family ipv4 unicast
!
address-family vpnv4 unicast
!
!
vrf vrf_1
rd 100:1
address-family ipv4 unicast
!
!
mpls ldp
router-id 2.2.2.1
interface GigabitEthernet0/2/0/3
!
!

Where to Go Next

To configure route maps through the RPL for OSPF Version 2, see Implementing Routing Policy on Cisco
ASR 9000 Series Router module.
To build an MPLS TE topology, create tunnels, and configure forwarding over the tunnel for OSPF Version
2; see Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide.

Additional References

The following sections provide references related to implementing OSPF.
Related Documents
Related Topic
OSPF Commands and OSPFv3 Commands: complete
command syntax, command modes, command history,
defaults, usage guidelines, and examples
MPLS TE feature information
MIB Reference
OL-30423-03
redistribute connected route-policy pass-all
redistribute ospf 1 match internal external
!
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
Document Title
Cisco ASR 9000 Series Aggregation Services Router
Routing Command Reference
Implementing MPLS Traffic Engineering on Cisco
ASR 9000 Series Router module in Cisco ASR 9000
Series Aggregation Services Router MPLS
Configuration Guide
Cisco ASR 9000 Series Aggregation Services Router
MIB Specification Guide
Where to Go Next
421