Vrf Address Family Configuration Mode; Family - Cisco ASR 9000 Series Configuration Manual

BGP Configuration

VRF Address Family Configuration Mode

The following example shows how to enter VRF address family configuration mode:
RP/0/RSP0/CPU0:router(config)# router bgp 112
RP/0/RSP0/CPU0:router(config-bgp)# vrf vrf_A
RP/0/RSP0/CPU0:router(config-bgp-vrf)# address-family ipv4 unicast
RP/0/RSP0/CPU0:router(config-bgp-vrf-af)#
Configuring Resilient Per-CE Label Allocation Mode Under VRF Address Family
Perform this task to configure resilient per-ce label allocation mode under VRF address family.
Resilient per-CE 6PE label allocation is not supported on CRS-1 and CRS-3 routers, but supported only
Note
on CRS-X routers.
SUMMARY STEPS
1. configure
2. router bgpas-number
3. vrfvrf-instance
4. address-family {ipv4 | ipv6} unicast
5. label mode per-ce
6. Do one of the following:
DETAILED STEPS
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)#
Enters global configuration mode.
Step 2
router bgpas-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 666
RP/0/RSP0/CPU0:router(config-bgp)#
Specifies the autonomous system number and enters the BGP configuration mode, allowing you to configure the BGP
routing process.
Step 3
vrfvrf-instance
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
16
• end
• commit
Implementing BGP
OL-30423-03