Cisco ASR 9000 Series Configuration Manual page 152

Configuring a VPN Routing and Forwarding Instance in BGP
SUMMARY STEPS
1. configure
2. router bgp as-number
3. vrf vrf-name
4. address-family { ipv4 | ipv6 } unicast
5. Do one of the following:
6. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 120
Step 3 vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config-bgp)# vrf vrf_a
Step 4 address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RSP0/CPU0:router(config-vrf)# address-family ipv4
unicast
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
124
• redistribute connected [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute eigrp process-id [ match { external | internal }] [ metric metric-value ] [
route-policy route-policy-name ]
• redistribute isis process-id [ level { 1 | 1-inter-area | 2 }] [ metric metric-value ] [ route-policy
route-policy-name ]
• redistribute ospf process-id [ match { external [ 1 | 2 ] | internal | nssa-external [ 1 | 2
]}] [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute ospfv3 process-id [ match { external [ 1 | 2 ] | internal | nssa-external [ 1 |
2 ]}] [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute rip [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute static [ metric metric-value ] [ route-policy route-policy-name ]
Purpose
Specifies the autonomous system number and enters
the BGP configuration mode, allowing you to
configure the BGP routing process.
Enables BGP routing for a particular VRF on the PE
router.
Specifies either an IPv4 or IPv6 address family unicast
and enters address family configuration submode.
To see a list of all the possible keywords and
arguments for this command, use the CLI help (?).
Implementing BGP
OL-30423-03