Editing Routing Policy Configuration Elements Using The Nano Editor; Editing Routing Policy Configuration Elements Using The Emacs Editor - Cisco ASR 9000 Series Configuration Manual

Nonattached Policy Modification

Editing Routing Policy Configuration Elements Using the Nano Editor

To edit the contents of a routing policy using the Nano editor, use the following CLI command in EXEC
mode:
A copy of the route policy is copied to a temporary file and the editor is launched. After editing, enter Ctrl-X
to save the file and exit the editor. The available editor commands are displayed on screen.
Detailed information on using the Nano editor is available at this URL: http://www.nano-editor.org/.
Not all Nano editor features are supported on Cisco IOS XR software.

Editing Routing Policy Configuration Elements Using the Emacs Editor

To edit the contents of a routing policy using the Emacs editor, use the following CLI command in EXEC
mode:
A copy of the route policy is copied to a temporary file and the editor is launched. After editing, save the
editor buffer by using the Ctrl-X and Ctrl-S keystrokes. To save and exit the editor, use the Ctrl-X and Ctrl-C
keystrokes. When you quit the editor, the buffer is committed. If there are no parse errors, the configuration
is committed:
RP/0/RSP0/CPU0:router# edit route-policy policy_A
----------------------------------------
== MicroEMACS 3.8b () == rpl_edit.139281 ==
if destination in (2001::/8) then
drop
endif
end-policy
!
== MicroEMACS 3.8b () == rpl_edit.139281 ==
Parsing.
83 bytes parsed in 1 sec (82)bytes/sec
Committing.
1 items committed in 1 sec (0)items/sec
Updating.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
532
edit route-policy
name
nano
edit
route-policy
name
emacs
Implementing Routing Policy
OL-30423-03