Apply Preset; Initial Position; Camera Parameters Configurations; Figure 27: Initial Position - Grandstream Networks GVC3210 User Manual

Apply Preset

If you have already set preset on camera, you can apply preset via one of the following two ways:

Access camera screen and press the digital keys on the remote control to adjust camera to the preset.

Access preset screen and press the digital keys to switch to the corresponding preset, press the yellow
shortcut key to apply.

Initial Position

Users can also define a preset as initial position when the GVC3210 boots up from LCD menu  Settings
 Peripheral  Camera, three options are available:

System default position: The GVC3210 will boot up at default camera position.

Position when power off: The GVC3210 will return to the last position before power off.

Custom: The GVC3210 will boot up at a custom position. When chosen, users will be redirected
to Preset settings page to set a custom preset.

Camera Parameters Configurations

Press the yellow shortcut key on GVC3210 remote control to bring out camera parameters setting screen
as shown below. Refer to the table below and configure the parameters using navigation keys on the remote
control.

Figure 27: Initial Position

GVC3210 User Guide
Version 1.0.1.18
P a g e | 51