User's Guide
Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Tap Settings on the home screen.
2. Tap General Settings > Network Settings > Wired LAN Setup.
3. Check the message, and then tap Start Setup.
4. Check the message, and then tap OK.
The screen automatically closes after a specific length of time if you do not tap OK.
5. Connect the printer to a router using an Ethernet cable.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Tap
on the home screen.
2. Tap the Wi-Fi(Recommended) icon.
The network status is displayed.
3. Tap Change Settings.
4. Tap Others > Disable Wi-Fi.
5. Check the message, and then tap Start Setup.
6. When a completion message is displayed, tap Close.
The screen automatically closes after a specific length of time if you do not tap Close.
Disconnecting Wi-Fi Direct (Simple AP) Connection
from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specific device, disconnect from the device
instead of the printer.
1. Tap
on the home screen.
Network Settings
40