Section 5 - Jlg Control System; Hand Held Analyzer; To Connect The Hand Held Analyzer - JLG 1930ES Service Maintenance Manual

5.1 HAND HELD ANALYZER

Analyzer Display
Escape Key
To return home or access
previous menu
Up & Down Arrow Keys
Value Selector

To Connect the Hand Held Analyzer:

1. Connect the four pin end of the cable supplied with
the analyzer, to the diagnostic port (refer toSection
3.1) and connect the remaining end of the cable to
the analyzer.
NOTE: The cable has a four pin connector at each end of
the cable; the cable cannot be connected back-
wards.
2. Power up the Control System by turning the lower
key to the platform position and pulling both emer-
gency stop buttons on.
3121166
SECTION 5. JLG CONTROL SYSTEM
m en u:
HELP: PRESS ENTER
Figure 5-1. Hand Held Analyzer
– JLG Lift –

SECTION 5 - JLG CONTROL SYSTEM

Enter Key
Stores and selects Top Level, Sub
Level, and item menus
Left & Right Arrow Keys
Used to move between Top Level,
Sub Level, and item menus
5-1