Drive Motor Removal
NOTE: Applies only to:
USA machines built S/N 0200170585 to Present,
Belgium machines built S/N 1200015159 to Present.
ENSURE THE BATTERY DISCONNECT SWITCH IS IN THE OFF
POSITION BEFORE REMOVING DRIVE MOTOR.
1. Disconnect the motor cable from the power control
module.
2. Drain the oil out of the unit by removing the cover
plug. Note the condition of the oil, replace if neces-
sary.
3121166
1. Drive Motor
2. Motor Mounting Bolts
Figure 3-10. Motor Removal
CAUTION
SECTION 3 - CHASSIS & SCISSOR ARMS
3. Washers
4. Motor Cable
3. Remove the two motor mounting bolts and washers.
4. Gently remove the drive motor (1).
– JLG Lift –
3-11