Motor Removal - JLG 1930ES Service Maintenance Manual

SECTION 4 - HYDRAULICS
NOTE: Be sure to remove and discard the plastic plug at the
oil inlet on the new pump before installing.
14. Check oring on valve block and replace if necessary
before installing the new pump.
4-10

Motor Removal

1. Remove the four bolts attaching the motor to the
valve.
2. Pull motor from valve.
3. Once all maintenance is performed and lift cylinder
assembly is reinstalled on the machine, remove fill
plug and refill tank with proper grade of oil by using
a funnel. Fill until oil weeps out of opening.
4. Replace plug and torque to 40 ft. lbs.
– JLG Lift – 3121166