Section 6 - Jlg Control System; 6.1 Introduction - JLG t350 Service And Maintenance Manual

6.1 INTRODUCTION

WHEN INSTALLING ANY NEW MODULE CONTROLLER ON THE
MACHINE, IT WILL BE NECESSARY TO PROGRAM THE CONTROL-
LER FOR THE PROPER MACHINE CONFIGURATION, INCLUDING
OPTIONS AND PROPERLY CALIBRATE THE TILT SENSOR.
IT IS A GOOD PRACTICE TO AVOID PRESSURE-WASHING ELEC-
TRICAL/ELECTRONIC COMPONENTS. SHOULD PRESSURE-
WASHING BE UTILIZED TO WASH AREAS CONTAINING ELECTRI-
CAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES, INC. REC-
OMMENDS A MAXIMUM PRESSURE OF 750 PSI (52 BAR) AT A
MINIMUM DISTANCE OF 12 INCHES (30.5 CM) AWAY FROM
THESE COMPONENTS. IF ELECTRICAL/ELECTRONIC COMPO-
NENTS ARE SPRAYED, SPRAYING MUST NOT BE DIRECT AND BE
FOR BRIEF TIME PERIODS TO AVOID HEAVY SATURATION.
Analyzer Display
Escape Key
To return home or access
previous menu
Up & Down Arrow Keys
Value Selector
3121198
SECTION 6. JLG CONTROL SYSTEM
Figure 6-1. Hand Held Analyzer
– JLG Lift –

SECTION 6 - JLG CONTROL SYSTEM

The JLG designed Control System is a 12 volt based con-
trol unit installed on the boom lift.
The JLG Control System has reduced the need for
exposed terminal strips, diodes and trimpots and provides
simplicity in viewing and adjusting the various personality
settings for smooth control of: acceleration, deceleration,
creep, min speed, and max.-speed for all boom, drive,
and steering functions.
The control system will control the voltage output to the
valves and pump, as programmed for smooth operation
and maximum cycle time. Ground control speeds for all
boom functions can also be programmed into the control
system.
The JLG Control System controller has a built in LED to
indicate any faults. The system stores recent faults which
may be accessed for troubleshooting.
The Control System may be accessed utilizing a custom
designed, hand held analyzer (Analyzer Kit, JLG part no.
2901443) which will display two lines of information at a
time, by scrolling through the program.
Stores and selects Top Level, Sub
Left & Right Arrow Keys
Used to move between Top Level,
Sub Level, and item menus
Enter Key
Level, and item menus
6-1