Motor Assembly
NOTE: Applies only to:
USA machines built S/N 0200152825 to S/N
020170585,
Belgium machines built S/N 1200008481 to S/N
1200015159.
1. Insert motor into back of gearbox. Motor will pilot on
the four bosses in the gearbox. Try to keep the end
of the motor shaft from causing damage to the lip
seal in the gearbox.
NOTE: The motor may need to be rotated to line up the sun
gear splines with the motor shaft splines.
3121166
1. Motor
2. Cable
Figure 3-19. Motor Assembly
– JLG Lift –
SECTION 3 - CHASSIS & SCISSOR ARMS
3. Bolt
4. Washer
2. Install the two motor mounting bolts. Torque to 9 - 11
ft-lbs (12 - 15 Nm).
3. Connect the end of the cable to the power control
module.
4. Fill the gearbox with oil ISO grade 68 oil or oil of a
similar viscosity (80W gear oil or 20W engine oil).
The gearbox will need to be filled with 10 oz of oil.
3-23