Machine Configuration Programming Information - Sevcon - 1600346 - JLG 1930ES Service Maintenance Manual

5.10 MACHINE CONFIGURATION PROGRAMMING INFORMATION - SEVCON - 1600346

NOTE: When configuring an ES scissors machine, the machine configuration must be completed before any personality set-
tings can be changed. Changing the personality settings first and then changing the model number of the machine con-
figuration will cause the personality settings to return to default.
Shaded entries are not available for the selected Market.
Configuration
Setting
Digit
1
2
1
3
(Model #)
4
5
0
1
2 2
(Market *) 3
4
5
3 0 NO - Drive and lift up not prevented while tilted (Ground and Platform Mode).
YES - Drive and lift up prevented while tilted (Ground and Platform Mode).
(Tilt Cutout) 1
4 0 No - Drive and lift up not prevented while elevated.
Yes - Drive and lift up prevented while elevated.
(Drive Cutout) 1
0 DRIVE ONLY - Drive motion prevented while vehicle is charging.
5
Drive and Lift Up - Drive and lift up motions are prevented while vehicle is charging.
(Charger Interlock)
Required for CE.
1
0 NOT INSTALLED - Vehicle alarm will function for Arm Guard (if enabled), Overload (if
LSS enabled, and as a horn.
6
DESCENT - Vehicle alarm will function for Arm Guard (if enabled), Overload (if LSS
1
enabled, as a horn and during Lift Down motion.
(Ground Alarm)
MOTION - Vehicle alarm will function for Arm Guard (if enabled), Overload (if LSS
2
enabled, as a horn and during Drive and Lift motion.
0 NOT INSTALLED - Load Sensing System (LSS) is not fitted to the vehicle.
CUTOUT PLT - Load Sensing System (LSS) is fitted and Platform Controls are pre-
1
7
vented in the event of an Overload. Ground Controls remain functional. This is the
default setting for CE machines.
(Load)
CUTOUT ALL - Load Sensing System (LSS) is fitted. Platform and GRound Controls
2
are prevented in the event of an overload.
8 0 PEERLESS - Vehicle is fitted with Peerless drive motors.
ADVANCED DC - Vehicle is fitted with ADvanced DC drive motors.
(Drive Motors) 1
0 NOT INSTALLED - Vehicle is not fitted with an Elevation Prox Sensor. Vehicle has
Left and Right Brake Release Outputs, and Maintained Brake Release functionality.
9
INSTALLED - Vehicle is fitted with an Elevation Prox Sensor (original ES-Series).
1
(Elev Prox)
Vehicle has a single Brake Release Output, and Momentary Brake Release function-
ality.
10 0 FLOODED - Batteries are conventional lead-acid type.
AGM - Batteries are absorbed glass mat type.
(Battery) 1
11 0 NO - Vehicle is not fitted with a footswitch
(Footswitch) 1 YES - Vehicle is fitted with a footswitch
3121166
Table 5-5. Machine Configuration Programming Information
(Machines with Sevcon - 1600346 Power Module Only)
Description
1930ES
2030ES
2630ES
2646ES
3246ES
ANSI USA
ANSI EXPORT
CSA
AUSTRALIA
JAPAN
– JLG Lift –
SECTION 5 - JLG CONTROL SYSTEM
CE
* Market Default Setting
0 1 2 3 4
(Set to your applicable ES Model
1 through 5)
0 - (ANSI USA)
(Set to your applicable market)
1 1 1 0 1
0
0 0 0 0 0
2 2 2 0 2
0 1 0 1 0
1
0
0
0 0 0 0 0
4150473-F
5-27
5
1
0
2
1
1