JLG 1930ES Service Maintenance Manual page 87

USA Built Machines S/N 0200170585 to Present &
Belgium Built Machines S/N 1200015159 to Present:
NOTE: The below procedures (1 - 19) apply to 1930ES only.
BE SURE TO PULL THE BATTERY DISCONNECT ANYTIME WORK
IS BEING PERFORMED ON THE DRIVE MOTORS OR DRIVE
MOTOR CABLING.
1. Orient the drive cables going back towards the rear
of the machine as shown below.
2. Loop the cables forward towards the front of the
machine then up and back so that the clamping
rings on the cables are aligned together.
3. Obtain the Cable Clamp and hardware.
1. Cable Clamp
2. Spacer Plate
3121166
CAUTION
3. Capscrew, Washers, and
Nut
SECTION 3 - CHASSIS & SCISSOR ARMS
15. Place the Green Clamp on the clamping rings as
shown below.
16. Bolt the clamp onto the underside of the frame.
a. The Spacer goes between the frame and the
Clamp.
b. Place the Larger Washer against the clamp.
17. Connect the drive motor cables to the power mod-
ule.
18. Tuck all wires into the power module compartment
and install cover.
1
19. Reconnect battery cable plug. Power up machine
and operate the drive function to ensure drive
motors operate properly.
– JLG Lift –
3 1
2
1. Drive Cables
2. Cable Clamp
3. Spacer Plate
3-51