Reboot; Reset - Proxim AP-4000 User Manual

Commands

Reboot

On clicking the Save button the Save As window displays, where the user is prompted to choose the filename and
location where the file is to be downloaded. Select an appropriate filename and location and click OK.
Reboot
Use the Reboot tab to save configuration changes (if any) and reset the AP. Enter a value between 0 and 65535
seconds; entering a value of 0 (zero) seconds causes an immediate reboot. Note that Reset, described below, does not
save configuration changes.
CAUTION: Rebooting the AP will cause all users who are currently connected to lose their connection to the network
until the AP has completed the restart process and resumed operation.
Figure 6-11 Reboot Command Screen

Reset

Use the Reset tab to restore the AP to factory default conditions. Since this will reset the AP's current IP address, a new
IP address must be assigned. See
CAUTION: Resetting the AP to its factory default configuration will permanently overwrite all changes that have made to
the unit. The AP will reboot automatically after this command has been issued.
Figure 6-12 Reset to Factory Defaults Command Screen
NOTE: The AP may also be reset from the RESET button located on the side of the unit. However, this action will not
reset the unit to factory default settings.
Recovery Procedures for more information.
AP-4000 Series User Guide
146