Led Indicators - Proxim AP-4000 User Manual

Installation and Initialization
AP-4000 Series Hardware Description
• The Active Ethernet (AE) integrated module receives ~48 VDC over a standard Category 5 Ethernet cable.
• To use Active Ethernet, you must have an AE hub (also known as a power injector) connected to the network.
• The cable length between the AE hub and the Access Point should not exceed 100 meters (approximately 325 feet).
The AE hub is not a repeater and does not amplify the Ethernet data signal.
• If connected to an AE hub and an AC power simultaneously, the Access Point draws power from Active Ethernet.
Also see Hardware Specifications.
NOTE: The AP's 802.3af-compliant Active Ethernet module is backwards compatible with all ORiNOCO Active Ethernet
hubs that do not support the IEEE 802.3af standard.

LED Indicators

The top panel of the AP-4000/4000M/4900M has the following LED indicators.
Power Wireless
Interfaces
Figure 2-3 LED Indicators on the AP-4000/4000M/4900M Top Panel
The LED indicators exhibit the following behavior:
Indication
Solid Green AP image running.
Blinking Green n/a
Solid Amber The Bootloader is
loading the application
software.
Blinking Amber The AP is reloading.
Solid Red Power On Self Test
(POST) running.
Blinking Red Rebooting.
Ethernet
Power Wireless Interface A
(802.11a radio)
Wireless interface A is
preparing for use.
Wireless interface A is
transmitting or receiving
wireless packets.
n/a
n/a
n/a
n/a
AP-4000 Series User Guide
Wireless Interface B
(802.11b/g radio)
Wireless interface B is
preparing for use.
Wireless interface B is
transmitting or receiving
wireless packets.
n/a
n/a
n/a
n/a
Ethernet
Ethernet interface is
connected at 100 Mbps
with no traffic.
Ethernet interface is
connected at 100 Mbps
with traffic.
Ethernet interface is
connected at 10 Mbps
with no traffic.
The Ethernet interface
is connected at 10
Mbps with traffic.
n/a
n/a
21