Proxim AP-4000 User Manual page 189

Command Line Interface (CLI)
Parameter Tables
DHCP Server table for IP pools
Name
DHCP Server IP Address
Pool Table
Table Index
Start IP Address
End IP Address
Width
Default Lease Time
(optional)
Maximum Lease Time
(optional)
Comment (optional)
Status (optional)
NOTE: Set either End IP Address or Width (but not both) when creating an IP address pool.
DHCP Relay Group
The DHCP Relay Group allows you to enable or disable DHCP Relay Agent Status.
Name
DHCP Relay Group
Status
DHCP Relay Server
Table
DHCP Relay Server Table
The DHCP Relay Server Table contains the commands to set the table entries. The AP supports the configuration of a
maximum of 10 server settings in the DHCP Relay Agents server table.
Name
DHCP Relay Server
Table
DHCP Relay Server
Table Entry Index
DHCP Relay Server
Table Entry IP Address
DHCP Relay Server
Table Entry Comment
DHCP Relay Server
Table Entry Status
Type
Table N/A
Integer User Defined
IpAddress User Defined
IpAddress User Defined
Integer User Defined
Integer32 > 0
86400 sec (default)
Integer32 > 0
86400 sec (default)
DisplayString User Defined
Integer enable (1)
disable (2)
delete (3)
Type
Group N/A
Integer enable
disable
Table
Type
Table N/A
Integer32 1 - 10
IpAddress User Defined
DisplayString User Defined
Integer enable (1)
disable (2)
delete (3)
create (4)
Value Access
R
N/A
RW
RW
RW
RW
RW
RW
RW
Value Access
R
RW
R
Value Access
R
R
RW
RW
RW
AP-4000 Series User Guide
CLI Parameter
dhcpippooltbl
index
startipaddr
endipaddr
width
defleasetm
maxleasetm
cmt
status
CLI Parameter
dhcprelay
dhcprelaystatus
dhcprelaytbl
CLI Parameter
dhcprelaytbl
dhcprlyindex
dhcprlyipaddr
dhcprlycmt
dhcprlystatus
189