Vlan/Ssid Parameters; Other Parameters; Wireless Multimedia Enhancements (Wme)/Quality Of Service (Qos) Parameters - Proxim AP-4000 User Manual

Command Line Interface (CLI)
Parameter Tables

VLAN/SSID Parameters

Name
VLAN
Status
Management ID

Other Parameters

IAPP Parameters
Name
IAPP
IAPP Status
Periodic Announce
Interval (seconds)
Announce Response
Time
Handover Time-out
Max. Handover
Retransmissions
Send Announce Request
on Startup
NOTE: These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.

Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters

The Wireless Multimedia Enhancements commands enable and configure Wireless Multimedia Enhancement/Quality of
Service parameters per wireless interface. The following two commands are part of the Wireless Interface Properties
table.
Type
Group N/A
Integer enable
disable (default)
VlanId -1 (untagged)
or 1 - 4094
Type
Group N/A
Integer enable (default)
disable
Integer 80
120 (default)
160
200
Integer 2 seconds
Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms
Integer 1 - 4 (default 4)
Integer enable (default)
disable
Value Access
R
RW
RW
Value Access
R
RW
RW
R
RW
RW
RW
AP-4000 Series User Guide
CLI Parameter
vlan
vlanstatus
vlanmgmtid
CLI Parameter
iapp
iappstatus
iappannint
iappannresp
iapphandtout
iapphandretx
iappannreqstart
211