Cli Monitoring Parameters - Proxim ORiNOCO AP-700 User Manual

Command Line Interface (CLI)

CLI Monitoring Parameters

Set Security Profile Parameters
Configure a Security Profile with Non Secure Security Mode
[Device-Name]>set secprofiletbl <index> secmode nonsecure status enable
Example:
[Device-Name]>set secprofiletbl 2 secmode nonsecure status enable
Configure a Security Profile with WEP Security Mode
[Device-Name]>set secprofiletbl <index> secmode wep encryptkey0 <value> encryptkeylength
<vakue> encryptkeytx <value> status enable
Example:
[Device-Name]>set secprofiletbl 3 secmode wep encryptkey0 12345 encryptkeylength 1
encryptkeytx 0 status enable
Configure a Security Profile with 802.1x Security Mode
[Device-Name]>set secprofiletbl <index> secmode 802.1x rekeyint 900 status enable
Example:
[Device-Name]>set secprofiletbl 4 secmode 802.1x rekeyint 900 status enable
Configure a Security Profile with WPA Security Mode
[Device-Name]>set secprofiletbl <index> secmode wpa rekeyint 900 status enable
Example:
[Device-Name]>set secprofiletbl 5 secmode wpa rekeyint 900 status enable
Configure a Security Profile with WPA-PSK Security Mode
[Device-Name]>set secprofiletbl <index> secmode wpa-psk passphrase <value> status enable
Example:
[Device-Name]>set secprofiletbl 6 secmode wpa-psk passphrase 12345678 status enable
Configure a Security Profile with 802.11i Security Mode
[Device-Name]>set secprofiletbl <index> secmode 802.11i rekeyint <value> status enable
Example:
[Device-Name]>set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable
Configure a Security Profile with 802.11i-PSK Security Mode
[Device-Name]>set secprofiletbl <index> secmode 802.11i-psk passphrase <value> status
enable
Example:
[Device-Name]>set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable
CLI Monitoring Parameters
Using the show command with the following table parameters will display operating statistics for the AP (these are the
same statistics that are described in the
• staticmp: Displays the ICMP statistics.
• statarptbl: Displays the IP ARP Table statistics.
• statbridgetbl: Displays the Learn Table.
Monitoring section).
AP-700 User Guide
173