Broadcast Ssid And Closed System - Proxim AP-4000 User Manual

Advanced Configuration
SSID/VLAN/Security
7. Enable or disable RADIUS accounting on the VLAN/SSID under the Accounting Status drop-down menu.
8. Enable or disable RADIUS MAC authentication status on the VLAN/SSID under the RADIUS Authentication Status
drop-down menu.
9. Enable or disable MAC Access Control List status on the VLAN/SSID under the MAC ACL Status drop-down menu.
10.Enter the Rekeying Interval in seconds. The default interval is 900 seconds.
11. Enter the Security Profile used by the VLAN in the Security Profile field.
NOTE: If you have two or more SSIDs per interface using a Security Profile with a security mode of Non Secure, be
aware that security being applied in the VLAN is not being applied in the wireless network.
12.Define the RADIUS Server Profile Configuration for the VLAN/SSID:
• RADIUS MAC Authentication Profile
• RADIUS EAP Authentication Profile
• RADIUS Accounting Profile
If 802.1x, WPA, or 802.11i security mode is used, the RADIUS EAP Authentication Profile must have a value.
A RADIUS Server Profile for authentication for each VLAN shall be configured as part of the configuration options
for that VLAN. RADIUS profiles are independent of VLANs. The user can define any profile to be the default and
associate all VLANs to that profile. Four profiles are created by default, "MAC Authentication", "EAP
Authentication", Accounting", and "Management".
13.Specify a QoS Profile. See the
14.If editing an entry, enable or disable the parameters on this page using Status drop-down menu. If adding a new entry,
this drop-down menu will not appear.
15.Reboot the AP.

Broadcast SSID and Closed System

Broadcast SSID allows the broadcast of a single SSID when the AP is configured for multiple SSIDs. Broadcast SSID
may only be enabled for a single SSID. This object can only be configured using the CLI and SNMP using a MIB browser
or network management application.
Closed System manages the way probe requests are handled. If enabled, the AP will respond to probe requests with an
SSID only if the client has specified the SSID in the probe request. If the client sends a probe request with a null or "ANY"
SSID, the AP will respond with a null SSID. If disabled, the AP will respond with each configured SSID, whether or not an
SSID has been specified in the probe request. This option is disabled by default.
For more information, on Broadcast SSID and Closed System, see Knoweldgebase Answer ID 1698 at
http://support.proxim.com.
Enabling QoS and Adding QoS policies
AP-4000 Series User Guide
section for more information.
128