Proxim AP-4000 User Manual page 179

Command Line Interface (CLI)
Other Network Settings
[Device-Name]>set telifbitmask <(see below)>
Choose from the following values:
Interface Bitmask
0 or 2 = Disable (all interfaces) All management channels disabled
1 or 3 = Ethernet only
4 or 6 = Wireless A only
8 or 10 = Wireless B only
12 = Wireless A and Wireless B Wireless A and Wireless B enabled
13 or 15 = All interfaces
Set Communication Ports
[Device-Name]>set httpport <HTTP port number (default is 80)>
[Device-Name]>set telport <Telnet port number (default is 23)>
Configure Secure Socket Layer (HTTPS)
Enabling SSL and configuring a passphrase allows encrypted Secure Socket Layer communications to the AP through
the HTTPS interface.
[Device-Name]>set sslstatus <enable/disable>
The user must change the SSL passphrase when uploading a new certificate/private key pair, which will have a
corresponding passphrase.
[Device-Name]>set sslpassphrase <SSL certificate passphrase>
[Device-Name]>show http (to view all HTTP configuration information including SSL.)
HTTP Group Parameters
=====================
httpifbitmask
httppasswd
httpport
httphelplink
httpsetupwiz
sslstatus
sslpassphrase
Figure A-15 Result of "show HTTP" CLI Command
Set Telnet Session Timeouts
[Device-Name]>set tellogintout <time in seconds between 1 and 300 (default is 30)>
[Device-Name]>set telsessiontout <time in seconds between 1 and 36000 (default is 900)>
Configure Serial Port Interface
NOTE: To avoid unexpected performance issues, leave Flow Control at the default setting (none) unless you are sure
what this setting should be.
Description
Ethernet only enabled
Wireless A only enabled
Wireless B only enabled
All management channels enabled
: 15
: ********
: 80
: file:///C:/Program Files/ORiNOCO/AP4xxx/HTML/index.htm
: disable
: enable
: ********
AP-4000 Series User Guide
179