Christie CP42LH Service Manual page 63

7. Remove the Light
8. Remove the 4 screws from the AC line filter plate.
9. Disconnect the J34 connector from the EVB and release the harness from the routing clips.
10. Remove the 8 screws from the front plate of the projector.
11. Remove the 2 screws from the inside (bottom of base plate).
12. Loosen the 2 thumbscrews on the front bracket, located behind the front plate.
13. Remove the 3 screws securing the high security interlock bracket.
14. Remove the front plate.
15. Remove the aperture plate access screw.
16. Remove the 4 screws securing the fold mirror cover.
17. Remove the 4 screws securing the IOS to the base plate.
18. Disconnect the connector from the color PC card.
19. Remove the IOS.
20. Recreate your Measured Color Gamut Data (MCGD) files. See the user manual for instructions.
CP42LH Service Manual
020-101686-03 Rev. 1 (08-2016)
engine, see page 58.
When installing the IOS, adjust convergence, fold mirror alignment, and integrator
alignment.
Parts and Module Replacement
63