Safety Information - Christie CP42LH Service Manual

Safety Information

Read all instructions before servicing. Always take extra precautions to secure all harnessing
properly, especially in the high voltage circuitry areas. Replace any wire with damaged insulation.
Components must be replaced with exact equivalents. Failure to do so may result in unsafe
operation.
General safety precautions
When working with the projector, observe these important safety rules to avoid personal injury or
damage to the projector:
When accessing a restricted access location for projector service or maintenance, avoid
exposure to the projector beam path by making sure to
• Turn the projector power off and disconnect the projector from AC power.
• Rotate the Beam Stop to Closed.
Failure to comply results in death or serious injury.
Failure to comply with the following could result in death or serious injury.
• The projection head must use Christie laser modules and laser rack.
• Never look directly into the projector lens. The extremely high brightness can cause
• FIRE HAZARD! Keep hands, clothes, and all combustible material away from the
• Qualified technician is required for all installations.
• Never operate the projector without all of its covers in place.
Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
Failure to comply could result in minor or moderate injury.
• This Christie laser projection system must be operated in an environment that meets the
• Always wear gloves and follow proper electrostatic discharge (ESD) precautions when
CP42LH Service Manual
020-101686-03 Rev. 1 (08-2016)
permanent eye damage.
concentrated light beam of the projector.
operating range specification.
handling, servicing, or cleaning components. Failure to comply may result in equipment
damage.
11