Light Engine Fans (Fans 1, 2, 3, And 4) - Christie CP42LH Service Manual

6. Push down the lever in the light engine compartment.
7. Pull the fan pack assembly out of the projector.

Light engine fans (fans 1, 2, 3, and 4)

Do not operate the projector with the light engine fan pack or light engine removed. This
causes overheating of the SFB FPGAs. Failure to comply may result in equipment damage.
Estimated replacement time: 10 minutes per fan
1. Remove the Fan pack
2. Disconnect the inline connector for the defective fan.
3. Release the harness from the routing clips.
4. Remove the fan and the rubber isolators.
Install the fan with the directional arrow facing into the projector.
Red FPGA fan (fan 5)
Estimated replacement time: 9.5 minutes
1. Remove the Fan pack
2. Disconnect the fan #5 inline connector from underneath.
CP42LH Service Manual
020-101686-03 Rev. 1 (08-2016)
assembly, see page 52.
assembly, see page 52.
Parts and Module Replacement
53