Emergency Shut Down - ATTACK PELLET 30 AUTOMATIC Plus Instructions For Use Manual

Emergency shut down

ATTENTION! In emergency case can be burner turned off by the main boiler switch and
disconnection of boiler power plug from electrical socket.
Cleaning and maintenance
Burner has to be cleaned after every consumption of 2.000 kg pellets. It is based on assumption, that
boiler keeps adequate amount of ash and the quality pellets are used.
It is also recommended to sweep boiler exchanger parts at least 2x a month.
1. Clean pellet inlet into burner by bottle brush or other suitebla kit
2. Scrape ignition plate a grate and clean the holes in grate
3. Open the lid of turbulators and remove remaining dust (e.g. by vacuum cleaner). Make sure,
that dust is not hot and it cannot burn bag of vacuum cleaner.
4. Once in 3 months it is necessary to dismantle rotary chimney part and to remove accumulated
dust.
ATTENTION! Keep ash in closed containers from inflammable material.
Maintenance once a year or in case of need (by a qualified person)
Select Burn-down by menu buttons and wait, until the fuel in burner burns out. Turn burner off by
burner switch and by main switch as well. Disconnect boiler plug from electrical socket. Open door
with burner for approximately 90°.
1. Dismantle burner covering and clean photocell by cloth and soft abrasive detergent (tooth
paste). Be careful by flat cable and buttons of display!
2. Clean blades of ventilator – it is the best to blow them with compressed air.
3. Dismantle scraper and ignition plate.
4. Clean space behind ignition plate
5. Scrape ignition plate and scraper
6. Brush the grate properly and clean holes in grate
7. Assemble all the parts back
8. Clean container and pellet feeder from dust and small dirts
9. Check state of the pellet inlet hose.
10. Start pellet feeder by connecting the plug into electrical socket (230 V~) to fill it with pellets.
11. Adjust the amount of pellets to be supplied
28