ATTACK PELLET 30 AUTOMATIC Plus – Boiler for pellet combustion
Important information:
Boiler for wood pellet combustion.
Installation, test heat-up and training of attendance must be performed by trained service
technician, who has to fill-in the protocol about boiler installation.
Recommended boiler operation temperature is 80–90°C. Lower operation temperature may cause
creation of condensate, shorter life-time of boiler and warranty expiration.
The only fuel to use are pellets, adequate to the approved fuel specification.
Appropriate boiler output represents very important condition of economic operation and correct
boiler function. Nominal boiler output has to be adequate to thermal losses of the heated object.
It is the responsibility of the installer to ensure compliance to all relevant building regulations.
Please, read this manual before starting-up the boiler.
Keep this manual for attendance on a suitable place in the boiler room. It is recommended to
keep it in a plastic pack and to hang it on a visible place on the wall to be reached by technician,
when doing service in your boiler room.
Boiler door and connections between boiler and chimney have to be airtight.
Overpressure in combustion chamber should be at least 5 pascal (0,5 mm of water column, resp.
0,05 hPa).
The PEL30AP appliance is intended for combustion of wood pellets and it cannot be used for
combustion of other fuel types.
The PEL30AP appliance for pellet combustion can be installed in a boiler room only, in
conformity with prescriptions of the local fire safety / construction authority.
WARRANTY FOR BOILER IS NOT VALID IF:
it is not operated with prescribed fuel - pellets adequate to the approved fuel specification.
there is no mixing device Regumat ATTACK-OVENTROP installed in the system to
ensure temperature of the boiler return water over 65°C.
WARNING SIGN
Warning sign is used in this manual to prevent potential hazards by breaking the instructions. Two
types of warnings are used in this manual:
WARNING – warns about dangerous situations and situations that may cause health injury
or damage by breaking the indespansable measures.
ATTENTION – warns about less dangerous procedures that may cause safety hazard or
damage of property.
3