ATTACK PELLET 30 AUTOMATIC Plus Instructions For Use Manual page 34

Modulation:
MODULATION.
ENTER < > EXIT
Setting the photocell sensitivity:
PHOTOSENS.
ENTER < > EXIT
photocell is installed correctly. Production setting is 50 %.
Selection of thermostat:
THERMOSTAT
ENTER < > EXIT
the start temperature as first and save the value by pressing „S" button. Then you can change stop
temperature and save it by „S". Burner will operate in the range of the actually adjusted
temperatures. Difference between start and stop temperature should be at least 5°C.
Grate cleaning:
SCRAPING
ENTER < > EXIT
Selection of language:
LANGUAGE
ENTER < > EXIT
Setting of output range:
EFFECT SPAN
ENTER < > EXIT
Setting of pellet dosing:
PELLET TRIM
ENTER < >
you work with parameter Heat value (kWh/kg). After entering this value, text „Put the bag on" is
displayed (pellet feeder should be totally filled with pellets). Put the bag on and press „S".
Watch the countdown on display, while the feeder works for 6 minutes. Then, enter weight of the
fallen pellets by pressing „+" and „–" a nd confirm / save it by „S" button.
Ventilator setting:
FANFACTOR
ENTER < > EXIT
34
By adjusted temperature difference ∆T, boiler output automatically
decreases under the set level before the required boiler temperature
is achieved.
Here you can set photocell sensitivity, i.e. value of light (in %) that
will control system consider as a flame.
It should not be necessary to adjust sensitivity for light, if the
Here you select the required thermostat: external boiler thermostat
or burner thermal probe or combination with room thermostat.
If you use burner thermal probe, you can set 2 parameters. Select
This parameter determines, if and when will be the grate cleaning
activated – before ignition or after burn-down.
You can select Slovak, Czech, English, German, Italian, French,
Spanish, Russian Hungarian or Greek language.
Burner can work with output range of 8– 14 kW, 14–22 kW or 22–
30 kW, according to the range determined by this parameter.
= The most important parameter of control system! Here you
can set pellet amount supplied by feeder by full operation.
EXIT
To set pellet amount you need bag and very precise scale. Firstly
By this parameter you can adjust flue gas by using the flue analyser
for CO and CO2 content in flue gas.