ATTACK PELLET 30 AUTOMATIC Plus Instructions For Use Manual page 33

Setting of test-blow time
TESTBLOW TIME
ENTER < > EXIT
increase the testblow time. Production setting is 15 sec.
Setting of transition phase:
TRANS.PHASE
ENTER < > EXIT
There are two parameters of transition: the first is 14 kW and the second is 30 kW. Time set by the
first parameter defines, how long it will take to achieve 14 kW (since the flame is detected) and
time set by the second parameter defines, how long it will take to achieve 30 kW (since the flame is
detected). Lower required output needs shorter time to be achieved.
Setting of supply during transition phase:
TRANS.FEED
ENTER < > EXIT
detection. Setting from production is 15% of full dosis for 14 kW.
Setting of cleanblow time:
CLEANBLOW TIME
ENTER < > EXIT
Setting of ash removing:
STOKER
ENTER < >
Setting of max. combustion time:
MAX. COMB. TIME
ENTER < >
Setting of min. pause between burn-down and ignition:
ANTI-CYCLING
ENTER < > EXIT
Testblow time represents period of ventilation of boiler and
chimney, before the combustion starts (10–100 seconds).
By boilers with difficulty to achieve own draught it is suitable to
Here you can set the period from the first flame detection until the
full pellet dosis is supplied according to the final output.
Here you can set fuel supply during transition period since flame
detection, until the 14 kW output is achieved.
Set the required fuel dosis to be supplied into burner after flame
Cleanblow is activated, when thermostat turns off and the value
detected by photocell decreases under 12 %.
Ash removing starts automatically in the intervals set from 1 to 200
hours for the pre-set operation period.
EXIT
By this parameter you can set max. period of permanent burner
operation.
EXIT
This parameter ensures, that the burner will not be started
immediately after burner-out, but after the adjusted period.
33