Scania Cv Ab 2016, Sweden - Scania PDE Operator's Manual

Fitting heat exchanger and charge air
cooler
1.
Fit the heat exchanger on the bracket.
2.
Fit the charge air cooler bracket and tighten
the screws as illustrated.
Note:
When the heat exchanger is re-fitted, the screw
(26 Nm) on the upper side must be fitted first.
Then fit the lower screws (50 Nm). Otherwise
there is a risk of serious damage.
Tightening torques for screws.
M6: 10 Nm
M8: 26 Nm
M10: 50 Nm
3.
Fit the coolant pipes to the heat exchanger.
4.
Fit the heat exchanger outlet pipe for sea wa-
ter.
5.
Fit the charge air cooler, inlet pipe from the
turbocharger and the outlet pipe. Check O-
rings, apply vaseline and push the pipes into
position. Torque tighten the screws.
6.
Fill the system with coolant according to
specification.
7.
Start the engine and check that no leakage
occurs. Check the coolant level and top up as
necessary.
IMPORTANT!
Use silicone or teflon-based grease to lubricate
the O-rings. Only lubricate the O-rings, too
much grease can cause leakage.
OPM 250 en-GB
1
53
© Scania CV AB 2016, Sweden
2
Cooling system