Engine Shutdown - Scania PDE Operator's Manual

Engine shutdown

1.
Run the engine without a load for a few min-
utes if it has been run continuously with a
heavy load.
2.
Switch off the engine.
Note:
The battery voltage must remain on for a few
seconds after the 15 voltage is switched off so
that the control units can store the values and
switch to standby mode.
10 prohibited engine shutdowns will cause a
torque reduction (70% of fuel quantity). Reset
the engine by switching it off correctly once.
IMPORTANT!
There is risk of post boiling and of damage to the
turbocharger if the engine is switched off with-
out cooling.
The power must not be switched off before the
engine has stopped.
OPM 250 en-GB 24
© Scania CV AB 2016, Sweden
Starting and running