Scania Cv Ab 2016, Sweden - Scania PDE Operator's Manual

Oil pressure
Information about the normal oil pressure and
lowest permitted oil pressure is contained in the
section headed Technical Data.
The engine management system has the follow-
ing alarm levels:
• At an engine speed below 1,000 rpm and an
oil pressure below 0.7 bar/10.2 psi.
• At an engine speed above 1,000 rpm and an
oil pressure below 2.5 bar/36.3 psi for longer
than 3 seconds.
The incorrect oil pressure alarm has the follow-
ing functions:
• Alarm only.
• Alarm and torque reduction by 30%.
• Alarm and engine shutdown.
• Alarm and engine shutdown override control.
Note:
High oil pressure (above 6 bar/87 psi) is normal
when starting a cold engine.
Charging indicator lamp
If the lamp comes on during operation:
• Check and adjust the alternator drive belts as
described under the corresponding inspection
point. See the Inspection section.
If the charging indicator lamp is still on, this
could be due to an alternator fault or a fault in the
electrical system.
Belt transmission
When the belt transmission is new, it may make
a squeaking noise when running. The noise is
normal and disappears after 50-100 hours of op-
eration.
The noise does not affect the service life of the
belt transmission.
OPM 250 en-GB 23
© Scania CV AB 2016, Sweden
Starting and running