Setup Review - Cardinal 205 Installation And Technical Manual

The 205 indicator allows several operational parameters to be reviewed and changed without
breaking the calibration seal. These operational parameters are:
To enable the Setup Review feature, with the indicator ON:
1. Press the ASTERISK/
'0;> (Function) prompt and alternately flashing off and on (all ON, weighing unit off,
then all OFF, weighing unit ON) the annunciators.
2. Press the ZERO/REVIEW key. The display will change to the prompt for the selection of
power-up zeroing ($'#>).
3. Using the same procedure as described in the Setup and Calibration section of this
manual make the required changes.
4. Press the ASTERISK/
5. To exit Setup Review, press the ASTERISK/
remaining prompts OR at anytime, cycle the power (press the ON/OFF key twice).
CALIBRATION "C" NUMBERS
The "" numbers are displayed only during the Test mode operation by pressing the
ASTERISK/ key then the UNITS/
UP ARROW
of the test operation and each number is displayed for approximately 4 seconds, allowing you
to record them. Each number may be up to three (3) digits in length. By recording these
numbers you will be able to return the indicator to its present calibration settings without using
test weights simply by entering the "" numbers. Refer to the Setup and Calibration, !
section of this manual for instructions on using the "" numbers.
If any components have been changed that affect calibration and/or your scale
is used in a commercial application and must be "Legal for Trade" you cannot
use "" numbers to re-calibrate.
8200-M024-O1 Rev G y 205 Installation & Technical

SETUP REVIEW

Power Up Zero Reset Enable/Disable
Sleep Mode Feature Enable/Disable
Auto Shutoff Feature Enable/Disable
Clear Tare Feature Enable/Disable
Serial Input / Output Configuration
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output Port 1
Continuous Output Port 2
Print Tab Settings
Printer Port Selection
Gross Weight
Tare Weight
Net Weight
Gross Weight Accumulator
Net Weight Accumulator
CRLF Data Format Termination
End-Of-Print Line Feeds
key. The indicator will respond by showing the
UP ARROW
key to return to the previous prompt.
UP ARROW
UP ARROW
key. The "" numbers are shown at the end
TEST
Continuous Output Format
Type
Continuous Output Format
Type
key to step through the
33