Setup Review - Cardinal 200 Installation And Technical Manual

The Model 200 Weight Indicator allows several operational parameters to be reviewed and
changed without breaking the calibration seal. These operational parameters are:
To enable the Setup Review feature, with the indicator ON:
1. Press the ASTERISK/
FUnCt= (Function) prompt and alternately flashing off and on (all ON, weighing unit off,
then all OFF, weighing unit ON) the annunciators.
2. Press the ZERO/
power-up zeroing (PUO=).
3. Using the same procedure as described in the Setup and Calibration section of this
manual make the required changes.
4. Press the ASTERISK/
5. To exit Setup Review, press the ASTERISK/
remaining prompts OR at anytime, cycle the power (press the ON/OFF key twice).

SETUP REVIEW

Power Up Zero Reset Enable/Disable
Sleep Mode Feature Enable/Disable
Auto Shutoff Feature Enable/Disable
Clear Tare Feature Enable/Disable
Serial Input / Output Configuration
Print Tab Settings
key. The indicator will respond by showing the
UP ARROW
key. The display will change to the prompt for the selection of
REVIEW
key to return to the previous prompt.
UP ARROW
8200-M035-O1 Rev C  200 Installation & Technical
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output Port 1
Continuous Output Format
Type
Continuous Output Port 2
Continuous Output Format
Type
Printer Port Selection
Gross Weight
Tare Weight
Net Weight
Gross Weight Accumulator
Net Weight Accumulator
CRLF Data Format Termination
End-Of-Print Line Feeds
key to step through the
UP ARROW
45