Setup Review; Automatic Shut-Off; Sleep Mode - Cardinal 748 Technical/Operation Manual

The 748 allows several operational parameters to be reviewed and changed without breaking the
calibration seal. These operational parameters are:
To enable the Setup Review feature, first turn the 748 off by pressing the OFF key. Press and hold
the GROSS key and press and release the ON/ZERO key. Release the GROSS key. The 748 will
respond by showing the prompt for the selection of power-up zeroing (PUO=). Using the same
procedure as described in the calibration section of this manual, make the required changes. A
chart illustrating the basic procedure is included in the manual for a quick reference but refer to the
CALIBRATION section for detailed information if in doubt.
NOTE: By pressing the PRINT key, setup review will jump to the Prt= prompt.
AUTOMATIC SHUTOFF
This feature will automatically turn the 748 off after a predetermined period of inactivity. To turn the
instrument back on you must press the ON/ZERO key. See ASH= on SETUP REVIEW chart.

SLEEP MODE

If this feature is enabled, the load cell excitation will be reduced and the display will be reduced to
one scrolling segment after remaining at zero for the selected time (1 - 9 minutes). Unlike the
Automatic Shutoff feature which only requires that there be no motion on the indicator to activate,
the Sleep feature requires that the indicator remain at zero (0) to activate. See SLP= on SETUP
REVIEW chart.

SETUP REVIEW

Power Up Zero Reset Enable/Disable
Blank Display on Motion Enable/Disable
Auto Shutoff
Sleep
Number of Preset Weight Comparators
Truck Storage Enable/Disable
Automatic Clearing of Tare Enable/Disable
Serial Data Port Configuration
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output
Printer Model Selection
CTS Enable/Disable
Print Positions (tab settings)
Time
Date
Identification
Gross Weight
Tare Weight
Net Weight
29