Setup Review - Cardinal 210 Installation And Technical Manual

The 210 indicator allows several operational parameters to be reviewed and changed without
breaking the calibration seal. These operational parameters are:
To enable the Setup Review feature, with the indicator ON:
1. Press the  key. The indicator will respond by showing the FUnCt= (Function) prompt
and alternately flashing off and on (all ON, weighing unit off, then all OFF, weighing unit
ON) the annunciators.
2. Press the ZERO/REVIEW key. The display will change to the prompt for the selection of
power-up zeroing (PUO=).
3. Using the same procedure as described in the Setup and Calibration section of this
manual, make the required changes.
4. Press the  key to return to the previous prompt.
5. To exit Setup Review, press the ENTER key to step the remaining prompts OR at
anytime, cycle the power (press the ON/OFF key twice).
8200-M585-O1 Rev D  210 Installation & Technical

SETUP REVIEW

Power Up Zero Reset Enable/Disable
Time Format
Sleep Mode Feature Enable/Disable
Auto Shutoff Feature Enable/Disable
Serial Input / Output Configuration
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output Port 1
Continuous Output Format
Continuous Output Port 2
Continuous Output Format
Print Tab Settings
Printer Port Selection
Time
Date
Consecutive Number
Gross Weight
Tare Weight
Net Weight
Gross Weight Accumulator
Net Weight Accumulator
Count
Piece Weight
67