Setup Review - Cardinal 220 Quick Setup Manual

To reviewed or changed parameters without breaking the calibration seal, with the indicator ON:
1. Press the ASTERISK key, then press the ZERO/REVIEW key.
2. If the setting displayed is acceptable, press the ENTER key to save it and proceed.
3. Otherwise, enter the new setting, then press the ENTER key to save it and proceed.
4. To exit Setup Review, press the ENTER key to step through the remaining prompts OR at
any prompt, cycle the power (press the ON/OFF key twice).
The operational parameters that can be reviewed and changed are:
LIGHT=
Current Light Level
LIGHT ON=
Backlight Turn-On Level
• The LIGHT ON= value must be less than LIGHT= to activate.
• Enter 0 for LIGHT ON= to have backlight always ON.
• Enter 99 for LIGHT ON= to never turn on backlight (always OFF).
FIND ETR=
View Electronic Talley Roll File
• If ETR able=YES
PWR UP Z=
TIME=
CLR TARE=
SERIAL?
BAUD X=
PARITY X=
BITS X=
STOPS X=
CONT X=
TYPE=
TABS?
PORT=
PRT BEG
If MODE OF OP=1 (ID Storage)
TMP ID1=
TMP ID2=
TMP ID3=
TP TIME=
TP DATE=
STO WT=
ID=
ID Prompt
If MODE OF OP=1 (ID Storage)
ID2= ID Prompt 2
ID3= ID Prompt 3

SETUP REVIEW

Power Up Zero Reset Enable/Disable
Time Format (12 or 24 hour Clock)
Clear Tare Enable/Disable
Serial Input / Output Configuration (both ports)
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output
Continuous Output Format (only if, CONT X=YES)
Print Tab Settings
Printer Port Selection
Printer Beginning
Temporary ID Prompt 1
Temporary ID Prompt 2
Temporary ID Prompt 3
Temporary Ticket Time
Temporary Ticket Date
Temporary ID Stored Weight
23