Table of Contents
Advertisement
The wireless transmitter inside the 750C weight indicator enclosure can easily be enabled and
configured for use on a Wi-Fi network.
Wi-Fi Features
Soft Access Point (AP) for setting credentials for Wi-Fi module
Setup option to select static or dynamic IP address
Built-in web server to display weight, height, and BMI
TCP/IP connection for continuous output of weight, height, and BMI
Enable and Configure Wi-Fi Networking
The 750C allows you to view and change network settings without having to perform setup
using the calibration switch. The operational settings are entered using the keypad.
When a prompt is displayed, press the
To retain the setting and proceed to the next prompt, press the
To change a setting, press the
the
key to save it. NOTE: Holding the
decrease the setting displayed.
NOTE: Factory Network Settings are:
To enable and configure Wi-Fi networking:
1. With the indicator turned Off, press and hold the
turn the indicator on.
2. The indicator will perform a lamp test, display the model number and software revision,
and then display the
3. When the is display showing
4. Next, press the
5. With the display showing
or
keys to select
6. The display will change to
acceptable, press the
setting and then press the
Allowable settings are:
NOTE: Select
(0 = Off) to use a static IP address or select
dynamic IP address assigned by a DHCP server. Consult with your network
administrator for the proper selection.
7. The next prompt will be
a. If
was set to
until the prompt
b. If
was set to
, the first octet of the static IP address. For example, if the static IP address is
"192.168.0.2", press the
key.
c. The next three prompts will be
octets of the IP address. Press the
of the IP address. Next, press the
setting for the octet, and then press the
8555-0547-0M Rev B 750C Wi-Fi and Bluetooth Manual
WI-FI NETWORKING
WI-FI SETUP
or
keys to select a new setting, and then press
,
prompt.
, release the
key until the prompt
press the
(1 = On), and then press the
. Press the
key again. Otherwise, press the
key to save it.
(0 = Off) or
(1 = On).
, the first octet of the static IP address.
(1 = On), nothing needs to be entered here. Press the
is displayed.
(0 = Off), press the
or
key until the display shows 192, and then press the
,
or
key to view the current setting.
or
key down will rapidly increase or
, and
, ( = Off and
key and then press the
key.
is displayed.
key to view the current setting. Press the
key to save it.
key to view the current setting. If it is
or
keys to select a new
(1 = On) to use a
key to view the current setting of
, and
for the remaining three
key to view the current setting of each octet
key until the display shows the correct
key. Repeat this for each octet.
key.
= On).
key to
key
1
Advertisement
Table of Contents
